Quick Start: Connect & Power On
This is step 2 of first-time setup, covering connecting the receiver and powering on the trackers. Trackers and receivers are already paired at the factory, so normally no re-pairing is needed.
Follow first-time setup in order: Check contents → Connect & power on → Assembly & wearing → Configure SlimeVR → VRChat setup → Continuous calibration (use the "Next" buttons at the bottom of each page).
Before You Start
- Neko Nya trackers and the straps
- Charging dock and receiver
- Receiver antenna
- A computer that can run SlimeVR
Before first use
Make sure the trackers are sufficiently charged, and read Charging & Safety first.
1. Connect the Receiver
- Attach the antenna to the receiver.
- Connect the receiver to a USB port on your computer.
- Keep the receiver away from large metal surfaces and leave the area around the antenna clear.
Done when: the computer recognizes a USB device, and SlimeVR shows the receiver or tracker status after startup.
2. Power On the Trackers
Batch power-on
Place the trackers into the charging dock and press the left button on the dock to power them all on.
Individual power-on
While a tracker is off, press the side button on the tracker to turn it on by itself.
Next Steps
Once the receiver is connected and the trackers are on, continue in order:
- Assembly & wearing — chest mount, straps and wearing check (open Assembly & wearing)
- Configure SlimeVR — install the software, detect devices and assign points (open SlimeVR software)
- VRChat setup & continuous calibration — complete the VRChat settings, first reset and continuous calibration
Power off in batch
To power off all trackers, press the batch power-off button on the left side of the receiver once while they are on. Follow the silk-screen marking on the actual receiver, and avoid confusing it with the SW0 button on the trackers and dock.